Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION OF SIDE BODIES AND TRIM
Before installing supply valves make sure that
the cartridge nuts are in place. The cartridge
and cartridge nuts were properly installed and
tested before leaving the factory. Although it is
unlikely, it is nevertheless possible that
through the handling of the valve by any num-
ber of persons, the cartridge nuts may not be
properly installed.
This should be carefully
checked at time of installation. If the cartridge
nuts are not properly installed, water pressure
could force the cartridge out of the valve.
Personal injury or water damage to the prem-
ises could result.
1. Thread lower mounting nut down the sup-
ply valve body. Place the flat support washer
TOP
MOUNT-
ING NUT
SUPPLY VALVE
MOUNTING WASHER
LOWER
MOUNTING NUT
INSTALLATION OF SPRAY ASSEMBLY
1. Install rubber washer over thread-
ed nipple of spray nozzle assembly
and place down through smaller
hole in bidet bowl. From below
install rubber washer, metal washer
and mounting nut and tighten.
2. Attach supply tube to spray as-
sembly nipple.
mounting nut.
2. From under the bidet, insert valve body up
through holes. Thread top mounting nut onto
valve body with flat side of nut toward bidet.
Screw nut down until top of valve body is 3/8"
(16mm) to 7/16" (18mm) from top of deck.
(See figure 1).
3. Repeat installation with the otherside
4. Hand tighten the mounting nuts from
underneth. Do not tighten completely until after
the installation of the supply lines.
5.Install handle knob onto stem extension. In-
stall handle screw and tighten. Turn handle
knobs to the RIGHT (clockwise) to "OFF" to
properly position handle knob inserts and
snap them into place.
on top of
t
h
e
3/8" (16mm)
to 7/16" (18mm)
C
DISCHARGE TUBE (SHORT)
TOP OF VALVE BODY
TOP
MOUNTING
NUT
FIGURE 1
KNOB INSERT
HANDLE SCREW
HANDLE KNOB
ESCUTCHEON
TOP MOUNTING NUT
MOUNTING WASHER
BOTTOM MOUNTING NUT
VALVE BODY
SUPPLY TUBE
FITTING
SPRAY NOZZLE
ASSEMBLY
RUBBER WASHER
RUBBER WASHER
METAL WASHER
MOUNTING NUT
3/8" X 3/8" X 20"
SUPPLY TUBE
Publicité
