Moen 5200 Serie Mode D'installation page 8

INSTALLATION OF DIVERTER VALVE
CAUTION: Always turn water OFF before
removing existing faucet or disassembling the
valve. Open valve handles to relieve water
pressure and to insure that complete water
shut-off has been accomplished.
1A. For bidet with large center hole (most ap-
plications), use trim ring, thick metal washer
and small rubber seal above deck and large
rubber cone seal below deck.
1B. For bidet with small center hole, use trim
ring, thick metal washer and flat rubber seal
above deck and small rubber seal below deck.
CAP
HANDLE SCREW
HANDLE
CARTRIDGE NUT
ESCUTCHEON NUT
ESCUTCHEON
DIVERTER VALVE
2. Install thin metal washer and mounting nut
from below deck and tighten securely with ba-
sin wrench (trim upper washer flush with out-
side edge of bidet valve).
3. Place escutcheon over diverter valve.
4. Install and lightly tighten escutcheon nut.
Install and firmly tighten the cartridge nut.
5. Place handle on diverter valve stem and
secure with handle screw. Press cap into
place on handle.
TRIM RING
THICK METAL WASHER
FLAT RUBBER SEAL
SMALL RUBBER SEAL
(RIB SIDE UP)
THIN METAL WASHER
NUT
SMALL HOLE
IMPORTANT:
CENTER WASHER UNDER VALVE
BEFORE TIGHTENING NUT
TRIM RING
THICK METAL WASHER
SMALL RUBBER SEAL
(RIB SIDE DOWN)
LARGE RUBBER
CONE SEAL
THIN METAL WASHER
NUT
BIDET DECK
FIG. 1B
BIDET DECK
FIG. 1A
LARGE HOLE
(Most Applications)