Moen 5200 Serie Mode D'installation page 10

CONNECTING SIDE BODIES TO
DIVERTER VALVE AND WATER SUPPLIES
1. Slide "TEE" onto inlet port and tighten com-
pression nut. NOTE: Check to insure ferrule
and nut are in place before installing "TEE"
onto inlet tube. Thread one end of each sup-
ply hose onto a side bodies, the other end is
threaded to the "TEE" connection inlet. Supply
hoses can be crossed or looped for ease of
assembly.
HOT SIDE
SUPPLY STOP
(not supplied)
INSTALLATION OF LIFT
ROD ESCUTCHEON:
1. Thread the mounting tube into the lift rod escutch-
eon. Place the rubber washer below the lift rod es-
cutcheon.
2. Insert the mounting tube through the bidet lift rod
hole from above. Place the metal washer on the
mounting tube. Thread the mounting nut onto the
mounting tube and tighten.
3. Install the remainder of the waste assembly as
shown .
2. Connect flexible supply tube (not supplied)
to supply stop valve and then to inlet port (bot-
tom port) on side bodies on both hot and cold
sides. Tighten side body and supply stop
valve connections.
COLD SIDE
FLEXIBLE SUPPLY TUBE
(not supplied)
LIFT ROD
ESCUTCHEON
RUBBER
WASHER
MOUNTING
TUBE
METAL
WASHER
MOUNTING
NUT
SUPPLY HOSE (cold side)
FLEXIBLE SUPPLY TUBE
(not supplied)
INLET PORT (long tube)
BIDET "TEE" CONNECTION
SUPPLY HOSE (hot side)