Scheduled Maintenance; Cleaning The Squeegee Tube; Cleaning The Filter And The Solution Tank - BETCO GENIE APS E83039-00 Mode D'emploi

1. CLEANING THE SQUEEGEE TUBE

Check the squeegee tube for clogging if the suction is insufficient or at periodic intervals. To clean the
tube proceed as follows:
1. remove the tube from the sleeve on the squeegee
2. Remove the other end from the recovery tank
3. Wash the inside of the tube with a jet of water, spraying from the end where the tank is inserted
4. Reinstall the tube
ATTENTION: Do not wash the tube that goes from the suction unit to the
suction plug

2. CLEANING THE FILTER AND THE SOLUTION TANK

1. Unscrew the plug on the suction tank
2. Remove and clean the filter
3. Reinstall the filter and the plug
ATTENTION: Always wear gloves when doing this operation to protect yourself
from contact with hazardous solutions
ATTENTION: Disconnect the rapid graft before removing the reservoir solution
(see image page 18).

SCHEDULED MAINTENANCE

17