Broan Elite E12000 Serie Mode D'emploi page 5

INSTALL THE DUCTWORK
(DUCTED HOODS ONLY)
NOTE: To reduce the risk of fi re, use only
metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most effi ciently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use
as few of them as possible. Larger ducting
may be required for best performance with
longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back
towards hood location. Use duct tape to
seal the joints between ductwork sections.
SPACING BAR INSTALLATION
To compensate possible depth voids between
the appliance and the wall, a plastic SPACING
BAR to be fi xed at the back of the appliance
by means of the three screws (3.9 x 6 mm)
is included. The 3 screws to be used are
contained in the accessory bag attached to
the plastic spacing bar.
Cut the spacing bar according to the distance
to be adjusted.
FIGURE 1
HOOD
24" TO 30" ABOVE
COOKING SURFACE
FIGURE 2
(3.9 x 6 mm)
- 5 -
ROOF CAP
6"
ROUND DUCT
ROUND
ELBOW
MOUNTING
SCREWS
WALL
CAP