Normal Function - auna AMP-CD950 DG Mode D'emploi

Connecting the speaker system
Connect the speaker terminals with speaker wires of the correct
diameter. Make sure that the speaker wires are as short as possible. Cut
approximately 10 mm of the wire. If the cable is exposed, wire it.

NORMAL FUNCTION

1. First, select the desired audio source by pressing the corresponding
button on the front panel of the unit or the remote control. You can
select from BASS, TREBLE ZONE 1, ZONE 2, ZONE 3, Zone 4, MP3, CD,
DVD, BT, OPT and AUX.
2. Adjust the main volume of the unit with the MULTI button or VOL+/
VOL- buttons on the remote control.
3. Adjust the volume of the desired zone with the ZONE button (11) on the
unit or the V4+, V4-, V3+, V3-, V2+, V2-, V1+, V1- buttons on the remote
control.
4. To adjust treble and bass, press the buttons Bass+, Bass-, Treb+, Treb-.
5. Press the MUTE button to mute. Press this button again to unmute.
EN
23