How To Use Your Vacuum Cleaner - Eureka 3670 Serie Guide Du Propriétaire

How to use your vacuum cleaner

Fig. 6
Fig. 7
Fig. 8
Fig. 9
6
Eureka Customer Service HELPLINE 1-800-282-2886
CAUTION: Do not plug in cleaner until you
understand all controls and features.
To Clean Bare Floors and Rugs
Step 1: Attach wands to hose handle.
Step 2: Place floor tool on end of wand. Press button
back to lower brush for bare floors. Press
button forward to raise brush for carpets.
Step 3: For models with telescopic wands, extend
wands by pushing lock button down and
pulling on lower wand until reaching desired
height (Fig. 6).
Step 4: Adjust to maximum suction by closing the slip
ring on the hose handle (Fig. 6).
K
Step 5: Rotate swivel cord hook
canister to release cord (Fig. 7).
Step 6: Plug cord into appropriate outlet.
Step 7: Push on/off switch
Press again to turn off (Fig. 8).
To Clean Stairs, Upholstery and
Window Treatments
(see page 4 for accessory details)
Step 1: Attach combination tool, crevice tool or turbo
nozzle (on some models only) to the end of the
hose. If additional reach is needed place wand
on hose handle first.
Step 2: Adjust to minimum suction by opening the slip
ring on the hose handle (Fig. 6).
K
Step 3: Rotate swivel cord hook
canister to release cord (Fig. 7).
Step 4: Plug cord into an appropriate outlet.
Step 5: Push on/off switch
Press again to turn off (Fig. 8).
To Use Blower Port
Step 1: Remove HEPA filter (on some models only).
See page 8 for details.
Step 2: Detach hose
attach to the blower port
the canister (Fig. 9).
Step 3: Rotate swivel cord hook
canister to release cord (Fig. 7).
Step 4: Plug cord into appropriate outlet.
Step 5: Push on/off switch
Press again to turn off (Fig. 8).
on bottom of
L
. Press once to turn on.
M
on bottom of
L
. Press once to turn on.
M
from front of canister
B
on the back side of
J
on bottom of
L
. Press once to turn on.
M
and
A