Publicité
Les langues disponibles
Les langues disponibles
ENERGY SAVINGS SYSTEM
Optimal energy efficiency 100% of the time – in use and out of use.
• Saves energy in four ways: energy efficient electronics, jam prevention,
standby mode and sleep mode.
• Sleep mode shuts down shredder after two minutes of inactivity.
1.
In sleep mode.
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and
could ultimately stop running. To avoid these problems,
we recommend oiling shredder each time user empties
waste bin.
CAUTION! Use only a non-aerosol vegetable oil
in long nozzle container, such as S-16094.
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are for maintenance-free
operation. However, on rare occasions the sensors may
become blocked by paper dust, causing the motor to
run even when there is no paper present.
1. Turn off and
unplug shredder.
PAGE 4 OF 15
PRODUCT FEATURES CONTINUED
or
2. To get out of sleep
mode, touch control
panel.
2. Locate auto-start
infrared sensor.
3. Insert paper.
MAINTENANCE
Follow oiling procedures below and repeat twice.
1. Apply oil
across entry.
NOTE: Two paper detection sensors are located
in the center of the paper entry.
3. Dip cotton swab
in rubbing alcohol.
2. Press and hold Forward (
for two to three seconds.
4. Using cotton swab, wipe away any
contamination from the paper sensors.
)
0521 IH-2607
Publicité
