Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly & Installation
Identify The Model of Tractor
This bagging system is designed for use on several different
tractor models. Prior to attempting to mount the bagger, it is
important to determine which model of tractor that you have.
To identify your tractor's model, simply pivot the seat upward
and locate the model plate on its underside. The model number
will consist of a combination of eleven number and letters.
The 5
, 6
& 7
digits in your model number determine the
th
th
th
model series. For example, 13WC762F065, 13AN795S001 and
13WN77KS011 are all 700-series tractors.
700-Series Tractors Only
If you are assembling this bagger for use on any 700-series model
tractor you will need to install the two tractor mounting brackets
packed in your bagger kit. If you are installing this bagger unit on
any other tractor, disregard these steps and move to Assemble
Mounting Brackets on the next page.
To install these brackets on a model 700-series tractor, follow
these steps:
1.
Install a shoulder bolt from your hardware pack on each
bracket, securing them with flange lock nuts also included
in the hardware pack. Refer to Fig. 4-1.
2.
Insert the clevis pins from your hardware pack on each
bracket, securing them with clip pins also included in the
hardware pack. Refer to Fig. 4-1
3.
Mount the 700 series tractor mounting brackets to your
tractor using four self-tapping hex screws included with
your kit . See Fig. 4-2.
8
Figure 4-1
Figure 4-2
4
Publicité
Table des Matières
