Assembly & Set-Up; Contents Of Carton; Hardware Pack - MTD EZ-Stow Manuel De L'utilisateur

Assembly & Set-Up

Contents of Carton

• One Hauler Assembly
• One Hardware Pack
NOTE: All references to LEFT, RIGHT, FRONT, and
REAR indicate the hauler position when seated in
the tractor's operator seat and facing forward.

Hardware Pack

1
4
2
3
Figure 3-1
The contents of the hardware pack are listed below
and referenced in Figure 3-1.
1. Two (2) Flat Washers, .760 x 1.490 x .060
(736-0351)
2. Two (2) Flange Washers, .781 x 1.590
(736-04228A)
3. Two (2) Lynch Pins, .1875 (714-0220A)
4. One (1) Lithium Grease (737-04085)
Hauler Preparation
1. Carefully unpack the contents of the carton
and unwrap and cut any cable ties securing
the contents in the carton.
2. Carefully stand the hauler up as shown in
Figure 3-2.
Figure 3-2
• One Tongue Assembly
• One Operator's Manual
3. Before installing the wheels, the axles and
the inside of the rims should be greased
with the packet of grease shipped with your
hauler. Approximately half of the package
should be used on each side. Apply some
grease to the exposed portion of the axle
and coat the axle completely. Squeeze a
small amount of grease into the rim.
4. Slide the inner flat washer from the
hardware pack, the tire and outer flanged
washer from the hardware pack onto the
axle as shown in Figure 3-3. Make sure the
valve stem on the tire rim is facing outward.
Figure 3-3
5. Install the lynch pins from the hardware
pack through the holes in the axles. Flip the
lynch pin down over the axle to secure the
tires in place. See Figure 3-4.
Figure 3-4
6. Carefully set the hauler down onto its
wheels.
7. Locate the panel latch on the front of the
hauler. Push the panel latch inward and raise
the sides of the hauler bed. See Figure 3-5.
• Two Wheel Assemblies
1
8. Repeat Step 7 on the other side of the bed.
9. With both sides now raised, lift the front
panel up and insert the front panel into the
side panels pull outward on the tabs until
they click into place. See Figure 3-6.
1
1 10. Lift the tailgate latches and then lift the
tailgate into place. See Figure 3-7.
2
3
2
Figure 3-5
2
1
Figure 3-6
1
1
2
Figure 3-7
5