MTD Twin Rear Bagger 19A30003OEM Mode D'emploi page 12

Masquer les pouces Voir aussi pour Twin Rear Bagger 19A30003OEM:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.
Slide the hinge pin into the hole located on the mounting
tab, as in Fig. 4-16. Use the cut-out window (See inset in
Fig. 4-16) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Fig. 4-17.
7.
Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Fig. 4-18, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
12
s
4 — a
ectiOn
sseMbly
Figure 4-16
Figure 4-17
& i
nstallatiOn
2
Figure 4-18
8.
Install both grass bags onto the bag support assembly
by inserting the front edge in first (1), as seen in Fig. 4-19,
and setting the back edge down (2) until it fits into the
assembly.
1
Figure 4-19
9.
Install one of the rubber chute straps onto the chute elbow
using one of the supplied clevis pins (711-05063), washer (736-
0204) and Bow-tie cotter pins (714-04040) from hardware
pack 689-00092B. See Fig. 4-20. Secure the end of the strap
utilizing the hole furthest from the end, insert the torsion
spring hook (732-04510A) into the other end.
10.
Install the deck mounting pin (711-05049), along with two flat
washers (736-0176), up into the chute elbow using hardware
pack 689-00092B and secure with a flange lock nut (712-3027),
as seen in Fig. 4-20.
11.
Install the shoulder bolt (738-0754) into the chute elbow from
the top side and secure inside the chute elbow using a flange
lock nut (712-04063) from the same hardware pack (689-
00092B). See Fig. 4-20.
1
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Twin rear bagger 19a30003000

Table des Matières