XciteRC 24000000 PARACOPTER RTF Mode D'emploi page 25

Finalisation
ATTENTION: if the wind is
stronger (also thicker branches move,
over 30 km/h), the PARACOPTER
must not be flown because it is dif-
ficult to control! Crash hazard!
ATTENTION: threading the stabilizing rod requires caution and care so that the parachute will not
damaged.
Connect the items in numerical order (1-3)
Thread the assembled rod through the hole in the parachute (4) and push it through the entire parachute.
Connect the end pieces (5 + 6) on the stabilizer bar.
For transport, the stabilizing bar can be removed.
PARACOPTER
Changing the location of the lines in the servo rods also affects the
angle of the parachute. A higher point increases the speed of the
PARACOPTER - the model can be easily adapted to different wind
conditions or requirements of the pilot.
EN
25