XciteRC 24000000 PARACOPTER RTF Mode D'emploi page 24

The pilot figure is mounted with the
included double-sided tape and a
screw on the chassis.
EN
Connnect the front yellow lines in the
eyes of the servo rods (A). The rear
red lines run through the small lateral
opening (B) on the propeller guard.
Now the rear red lines are connected
in the round eyes of the hook sus-
pension lines (white). The suspension
lines then is hooked into the holes of
the servo rods - take note at the wind
speed:
With a gentle breeze use the middle
position in the servo rods, with a mo-
derate breeze the second position
from the top
The wind speed (wind) can be easily
estimated from a deciduous tree: with
a gentle breeze (about 16 km/h) only
the leaves move on a tree, with a mo-
derate breeze (about 30 km/h) also
thin branches.
24
Front lines (yellow)
Front lines (yellow)
Hook suspension
lines
Rear lines (red)
Finalisation
Rear lines
(red)
gentle
breeze
moderate
breeze
PARACOPTER