Titanwolf 303166 Mode D'emploi page 16

Note: Please remember the "Z" and "Y" are reversed. To configure, use the other
letter than the one desired to get the right result.
5.2.2 DPI
In the DPI settings, you have the option of configuring 6 individual DPI levels for
each profile.
5.2.3 LED
The logo light indicates which profile is currently active. The following are the
default colours of the preset DPI levels:
• Red: DPI level 1
• Green: DPI level 2
• Blue: DPI level 3
• Violet: DPI level 4
• Turquoise: DPI level 5
• Yellow: DPI level 6
You can adjust the LED lighting of the logo separately for each DPI level. You can
select the colour, brightness and breathing-speed (pulsing) as desired to customise
the appearance. The respective DPI colours can be adjusted under "Light setting".
5.3 Creating macros
Macros are recordings of specific key sequences, which can be run by pressing a
single mouse button depending on the configuration. This can, for example, be
keystrokes or mouse commands. To define a macro, please click on the desired
button and then select "Macro" and "Macro Manager" from the list as described
in section 5.2.1.
To start recording a new macro, first click on "NEW" and then specify a name. The
recording can be started using the "START" button and stopped using the "STOP"
button. Additional options are available on the right side of the Macro Manager
for recording the steps. In this way, you can define whether the time between
pressing the individual buttons and the stop times are measured and recorded,
16 English