Step 11, Adjust Door Swing; Step 12, Attach Hinge Guard - GE Monogram ZIC30GNNII Instructions D'installation

STEP 9 REVERSE DOOR SWING
13. With another person holding the door in place,
align the holes in the door hinge bracket with the
holes in the hinge. Install the screws to the top
hinge first.
14. install screws on the bottom hinge next.
15. Using a Torx T-20 wrench, tighten the tension on
the hinge springs by turning the screws from 0 to
Use Torx
T-20 Wrench
STEP 10 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop. When
space does not allow the door to swing to 115°, you may
limit the door swing to a 90°
Skip this step if door opening is satisfactory for your
installation situation.
• Open the fresh food door to access the top and bottom
hinges.
• Loosen the bottom hinge screws that attached to the
unit
• Pull hinge forward slightly & insert hinge pin into the
hole nearest the unit.
• You may need to use a small hammer to fully seat
them in place.
• Retighten hinge screws.
• Repeat for top hinge.
Installation Instructions
.
(cont)
Door
Screws
.
|
(if needed)
Install 1 pin,
per hinge for
90° door stop.
Hinge screws
18
STEP 11 ATTACH HINGE GUARD
WARNING:
This appliance must be installed & operated with the
hinge guard in place !
1. Tape hinge guard cover to side of case. Align cover
with top and front edges of case.
2. Attach hinge guard by sliding flat part between case
and hinge guard cover.
3. Fasten guard to door front using 4 screws.
Cover
Hinge guard