Toparc 063228 Mode D'emploi page 5

Translation of the original manual
WARNING - SAFETY RULES
GENERAL INSTRUCTIONS
Read and understand the following safety instructions before use.
Any modification or update that is not specified in the instructions manual should not be undertaken.
The manufacturer is not liable for any injury or damage due to a non-compliance with the instructions featured in this manual.
If there is any issue or uncertainty, please consult a qualified person to handle the installation correctly.
POSSIBLE RISKS IN RELATION TO POWER SUPPLY AND CONNECTIONS
• Pressurised air can cause serious damage.
• Always stop the air flow and disconnect the tool from the line to replace accessories, repair it or if you are not using it.
• Do not direct the air jet at other people or yourself; always use the tool at a safe distance from people near the work area.
• Fast moving pipes can cause serious damage; check pipes and connections carefully for loss or breakage.
• Do not use the quick-change connections on the tool, they could weigh it down and loosen due to vibration.
• Read the instructions for correct assembly.
• Whenever you use universal swivel couplings, use a locking pin.
• Do not exceed the maximum air pressure limit of 6.2 bar or the value indicated on the plate of the pneumatic tool.
• Handle hoses and connectors with care. Do not hold the pipe to carry the machine. Do not use excessive force to pull the air connector out. Keep
pipes away from heat sources, lubricants and sharp edges.
• Check the hoses for wear before use. Check that all connections are secure.
RISKS CAUSED BY FRAGMENTS
• Always use eye and face protection equipment when using the tool.
• Smaller fragments could also cause eye damage and blindness.
• The explosion of pneumatic tools can cause serious damage.
AVOID BECOMING ENTANGLED
• Keep a suitable distance from working drills, blades, moving tools, etc.
• Do not wear rings or loose clothing.
• When you are near the tool and its accessories, be wary of your hair getting entangled.
RISKS CAUSED BY OPERATION
• Avoid direct contact with the shaft and its accessory if they are in motion to avoid injury.
• Wear protective gloves.
• Do not modify the tool or its accessories.
• Operators and maintenance personnel must be physically able to handle the power of the tool and follow the necessary procedures.
• Do not force the tool; if you use it at the speed for which it was designed, its performance will be better and more reliable.
DANGERS CAUSED BY WORKING CONDITIONS
• Slipping, tripping and falling are the main causes of accidents.
• The high noise level can cause permanent damage to hearing. Employers and work safety bodies recommend the use of ear protectors.
• Keep your body in balance and firmly on your feet. Repetitive work movements, unusual positions and exposure to vibration can be harmful to your
hands and arms. In case of numbness, tingling, pain or pallor, stop using the tool and consult a doctor.
• This tool is not suitable for use in hazardous areas.
SAFETY STANDARDS FOR THE USE OF THE TOOL
• Handle the mini milling machine with care to ensure long-lasting performance.
• Wear eye and ear protection, a half mask and protective gloves when using the tool.
• Use the mini milling machine in ventilated areas.
• Do not use the tool in hazardous areas and use it away from combustible materials; contact of the tool with metals produces sparks.
• Do not hold the devide by the pipe.
• Abrasives heat up during use. Allow them to cool down before touching them. Disconnect the air hose when changing or adjusting the abrasives.
Always use eye protection to avoid injuries caused by debris or parts ejected at high speed when operating the tool.
High sound levels can lead to permanent hearing loss. Use hearing protection during operation.
The risk of vibration hazard from Repetitive work motions, awkward positions and exposure to vibration may be harmful to your hands
and arms.
MINI MILLING MACHINE EN
5