Topfield SRP-2401CI+ Guide D'utilisation page 4

Connecting the TV
Connect any components before plugging the power cord into the wall outlet. If you encounter
any problems setting up your product, please contact your local retailer.
1. Connect the antenna cable from the satellite dish to the LNB 1 IN con-
2. Connect the LNB 1 OUT and LNB 2 IN connectors using a loop cable
NOTE
If you have connected both tuners with a loop cable, select the Instal-
lation icon and set the LNB Setting > Connection Type option to Loop
Through; otherwise, set it to Separated.
If you have two antennas without DiSEqC switch, you can connect the
cable from the other antenna directly to the LNB 2 IN connector rather
than using the loop cable.
NOTE
If there are too many antenna devices to be simultaneously supplied
with sufficient power for a rather long time through the antenna input
connections, then your antenna may lack power to operate. So it is rec-
ommended to link the LNB 1 OUT connector to the LNB 2 IN connector
with a loop cable, even though the digital receiver is designed to oper-
ate independently over two antennas.
3. Choose a setup that matches the connection ports on your TV.
– We recommend using the HDMI connection for the highest quality HD picture.
– For a higher quality use the component connection.
– For a basic connection to your television use the Scart or composite connection.
• HDMI connection (HDMI)
4
nector.
so that both tuners work properly for recording different channels at
the same time.