Format S 1 Instructions D'utilisation Et De Montage page 9

oPeRating and Mounting instRuCtions
s1 safes according to en 14450
However, the fastening material must meet the following requirements:
Anchor bolt or threaded rod:
Hexagon nut DIN / ISO 934:
Washer DIN / ISO 125:
dowel:
The expansion dowel M12S provided is suitable for load-bearing surfaces made of concrete,
aerated concrete, solid brick or sand-lime bricks.
important:
Before anchoring it, make absolutely certain that the subfloor is suitable for the fastening
material provided, and that there are no cables, lines, pipes or the like in the drilling area.
Otherwise, another type and / or place of fastening must be selected.
3.2 anCHoRing WitH tHe enClosed Fitting MateRial
Set up the vault at the intended location and align it so it is in balance. Mark the drilling po-
sition in the area to be anchored through the anchoring holes in the vault, and then remove
the vault again from the drilling area.
Drill a minimum depth of 100 mm into the substrate using a Ø 16 mm stone drill. Now clean
the borehole (extract drilling dust) [1].
Insert the dowel into the hole [2] and return the vault to its final position. Now bolt the safe
with the screw M12 and the washer. The thread can be easily chamfered so it is easier to
insert the screw or threaded rod [3].
In the event of break-in / theft, your insurer will not be liable for property damage or
pecuniary damage if improperly anchored.
1) Mark drilling
position and drill
(Ø16 mm, at least 100
mm deep)
Thread M12 / strength class 8.8
Thread M12 / strength class 8.8
Internal diameter 13 mm / external diameter 24 mm
/ thickness 2.5 mm
2) Clean the drill hole
and hammer in the
dowels
3) Position the safe
and insert screw M12
with U-washer
EN
9