CLEANING
WATER DISPENSER
Grille -
Wipe with a wet cloth, and dry with a dry cloth.
Water Tank -
1. Putting the Water
Is not necessary to remove the water tank in order to supply
it (it could be filled like shows fig. 1 pulling the tank gate).
NOTE
- Before closing door, close the cap and clamp tightly.
- Do not use liquids containing sugar or carbonated drinks like soda
2. Disassembly
Lift the water tank, gripping a side and bottom of water tank.
NOTE
When disassemble Water Tank, use all waterinside dispenser first.
3. Assembly
If by some cause removes the water tank, place again the water
tank on its original position. Verify that the valve assembly
correctly in the hole of the door (fig. 3,4). Once assembled push
down and check the tank position with line.
Water Tank -
1. Remove the tank cover.
2. Clean the inside and outside of the water tank
with diswashing detergent and rinse
throughly under running water. Dry the water
with a cloth.
(OPTIONAL)
fig. 1
fig. 2
fig. 3
fig. 4
3. Clean the inside and outside of the cap
with diswashing detergent and rinse
throughly under running water. Dry the water
with a cloth.
1. Use lukewarm water when cleaning.
2. Do not use anything other than water. If it is
used with soft drinks,put water in the water
tank and discharge three or four cups of
water shortly.
17
Caution