Model Gir60 - 60" Ranges - Garland G Serie Manuel D'installation Et D'opération

INSTALLATION Continued
Model GIR60 – 60" Ranges
DETAIL
I
Figure 3 – With area detail defi ned for 60 inch range.
NOTE: Instructions are for mounting the salamander on the
right side, for mounting on the left side follow the same
directions except use references 1, 2, 3, & 4 (to the left of
detail II see below) in lieu of A, B, C, D for detail II in the
following steps.
1
3 4
Part # 4523916 Rev 2 (05/05/14)
DETAIL
II
60" RANGE
DETAIL
II
A B
2
C D
1. Remove screws from back of oven on both sides of the
range (detail I) and center (detail II) as shown:
DETAIL I
ALL 60" MODELS
REMOVE
2 SCREWS
IF REQUIRED
FOR 60" RANGES
WITH STANDARD OVEN
REMOVE
2 SCREWS
IF REQUIRED
FOR 60" RANGES
WITH CONVECTION OVEN
2. Install the left and right support brackets (part # 4523226
and 4523227) using the 2 screws removed in step 1
(detail I) and one additional screw on both sides of the
range, and center support bracket (part # 4523282) with
the four screws removed in step 1 (detail II).
INSERTED
SCREWS
REMOVE
2 SCREWS
FROM BOTH SIDES
A B
REMOVE
2 SCREWS
IF REQUIRED
C D
DETAIL II
A B
REMOVE
2 SCREWS
IF REQUIRED
C D
DETAIL II
DETAIL I
ALL 60" MODELS
Page 13