Garland G Serie Manuel D'installation Et D'opération page 12

INSTALLATION Continued
3. Slide the salamander down into the support brackets
installed in step 2, see fi gure 2. NOTE: On ranges with 2
space saver ovens, the center post must slide into the
center channels built into the back of the unit.
4. Once the salamander is in place, fasten it to the unit on
both sides of the range with the provided #14B x 5/8 hex
washer head tapping screws.
PROVIDED
#14B x 5/8 HEX
WASHER HEAD
TAPPING SCREWS
5. For center support, (detail II) re-insert screws removed in
step 1 or provided sheet metal screws as shown in detail
II and III, inserting screws for detail III through clearance
in back panel.
FOR 48" RANGES WITH
STANDARD OR CONVECTION OVENS
AND STORAGE
CLEARANCE
HOLE
SCREWS
REMOVED
IN STEP 1
PROVIDED
SHEET METAL
SCREW
2 SCREWS
REMOVED
IN STEP 1
Page 12
DETAIL I
ALL 48" RANGES
INNER
HOLES
CLEARANCE
HOLE
DETAIL III
DETAIL II
FOR 48" RANGES WITH
2 SPACE SAVER OVENS
CLEARANCE
HOLE
SCREWS
REMOVED
IN STEP 1
3 PROVIDED
SHEET METAL
SCREWS
2 SCREWS
REMOVED
IN STEP 1
6. Re-insert screws removed in step 1 though clearance hole
in back panel as shown:
CLEARANCE
HOLE
REMOVED
SCREW
DETAIL IV
ALL 48" RANGES
INNER
HOLES
CLEARANCE
HOLE
DETAIL III
DETAIL II
Part # 4523916 Rev 2 (05/05/14)