Installation Of A Salamander To A Range; Model Gir36 - 36" Ranges - Garland G Serie Manuel D'installation Et D'opération

INSTALLATION Continued

Installation Of A Salamander To A Range

NOTE: The back of the range must be easily accessible.
Model GIR36 – 36" Ranges
DETAIL
I
Figure 1 – With area detail defi ned for 36 inch range.
1. Remove screws from back of oven (on both sides of
range) as shown:
REMOVE
2 SCREWS
(BOTH SIDES)
Page 10
LIFTING TECHNIQUES
36" RANGE
DETAIL I
SAFETY
FIRST
USE PROPER
2. Install the left and right support brackets (part # 4523226
and 4523227) by re-inserting the 2 screws removed in
step 1 and one additional screw (on both sides of the
range).
INSERTED
3. Slide the salamander down into the support brackets
installed in step 2, see fi gure 1.
4. Once the salamander is in place, fasten it to the unit on
both sides of the range with the provided #14B x 5/8 hex
washer head tapping screws.
PROVIDED
#14B x 5/8 HEX
WASHER HEAD
TAPPING SCREWS
SCREWS
DETAIL I
DETAIL I
Part # 4523916 Rev 2 (05/05/14)