LaserLiner CompactCross-Laser Pro Mode D'emploi page 14

Inserting batteries
1
Open the battery compartment and insert
batteries (2 x 1,5V LR6 (AA)) according
to the symbols. Be sure to pay attention
to polarity.
Horizontal and vertical levelling
2
Release the transport restraint, move the ON/OFF switch (4) to the left.
The laser cross will appear. The laser lines can be switched individually with
the selection button.
LASER
The transport restraint must be released for horizontal and vertical
levelling. The LED (2) shows a permanent green light. The laser lines
!
flash, the LED (2) lights red and a signal sounds when the device
is outside the automatic levelling range of 4°. Position the device
such that it is within the levelling range. The LED (2) switches back
to green and the laser lines stop flashing (steady light).
14
EN
LASER LASER
–
+
–
LASER