Care & Maintenance - Levoit Core 400S Smart True HEPA Serie Manuel De L'utilisateur

EN
C A R E & M A I N T E N A N C E
Cleaning the Smart Air Purifier
• Unplug before cleaning.
• Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
• Vacuum the inside of the air purifier.
• Do not clean with abrasive chemicals or
flammable cleaning agents.
Check Filter Indicator
will light up as a reminder to check the
filter. Depending on how often you use the air
purifier, the indicator should turn on at about
12 months. You may not need to change your
filter yet, but you should check it when
turns on.
When your air purifier is set up with the
VeSync app, you can also check the app to
see your remaining filter life. You will also
receive a notification from VeSync when it's
time to check your filter.
The VeSync app uses a scientific algorithm to
determine your filter life based on air quality,
amount of use, and other factors. The filter life
percentage is based on 12 hours of daily use.
Filter
Pre-Filter
True HEPA
& Activated
Carbon Filter
14
When to Clean
Every 2–4 Use a soft brush or vacuum
weeks
Do not clean
Resetting the Check
Filter Indicator
Reset the Check Filter Indicator when:
lights up red.
A.
1. Replace the filter (see page 15).
2. Turn on the air purifier.
3. Press and hold the
3 seconds.
4. will turn off when successfully
reset.
The filter was changed before
B.
lit up.
1. Press and hold the
3 seconds.
2. The
3. will turn off when successfully
reset.
Cleaning the Filter
The outer pre-filter should be cleaned every
2–4 weeks to increase efficiency and extend
the life of your filter. Clean the pre-filter using
a soft brush or vacuum hose to remove hair,
dust, and large particles. [Figure 3.1] Do not
clean the filter with water or other liquids.
How to Clean
hose [Figure 3.1]
button for
button for
will flash for 3 seconds.
Figure 3.1
When to Replace
12 months