Axis P55-E Serie Mode D'emploi page 16

AXIS P55-E Network Camera Series
2.
Network connector and network connector shield
3.
Ground screw T20
4.
Washer
5.
Cable shoe
5. Attach the grounding wire (torque 1.5 to 2 Nm) to the cable shoe using cable shoe pliers.
6. Put the cable shoe and washer back in their original positions and tighten the screw
(torque 0.5 Nm). Make sure the cable shoe is in contact with the grounding surface.
7. Connect the supplied RJ45 Push-pull Connector (IP66) to the network cable according to
the instructions supplied with the connector.
1
Screw
2
Slots for unit holders
3
Safety wire
8. Connect the network cable to the camera.
9. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
10. Secure the network camera to the mounting bracket by tightening the screws.
Access the Product
AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from www.axis.com/techsup
The product can be used with most operating systems and browsers. The recommended browsers are
• Internet Explorer
®
• Safari with OS X
3
® ®
with Windows
®
16
1
2