Publicité
Les langues disponibles
Les langues disponibles
C -
LED 1 always on = channel coupled to another transmitter
! Hold down
key
1
until a single acoustic signal sounds; then
release it:
LED 1
lis flashing (fig.
coupled to the receiver.
On the TRANSMITTER: deactivate "Test" mode.
N.B.:
to replace a transmitter coupled to a channel, proceed as described in
Coupling other transmitters to the remaining free channels
Select "Test" mode on the next transmitter to be paired, then repeat all the steps given above.
ATTENTION:
the coupling to channels and assigning the master are not cancelled by the
failure.
N.B.: test mode on the transmitter automatically terminates 3 minutes from activation.
2. - RECEIVER SETTING FOR OPERATION WITH "MASTER"
5
COUPLIN
G ZONES WITH MASTER
!
Only chronothermostat models with a "Master" function can be used to control the system's "Master" mode.
!
Only one "Master" transmitter can be paired with each channel, but the same "Master" transmitter can be paired with more
than one channel (paired exclusively or with another transmitter).
!
More than one "Master" transmitter can be paired with one 8 zone radio receiver.
!
A "Master" transmitter that has not been paired with any channel as a primary device can nevertheless be paired with the
receiver channels as a "Master".
!
Free channels cannot be paired with "Masters".
COUPLING CHANNELS WITH MASTERS
Select "Master Test" mode on the MASTER
!
Press the
"Master" key
until
(
See
"Pairing the Master"
ON THE RECEIVER:
The channel LEDs can be in the following states:
LED on = channel already paired with another "Master"
LED flashing = channel already controlled by the active "Master"
LED off = channel free and not paired with the active "Master"
Example: pairing channel 2
!
Press and hold the
key
2
Both
LEDs
flash Channel 2
.
chronothermostat (fig.
11
!
Repeat the above operation with all the free channels you want to pair with the
"Master".
Exit "Master Test" mode on the MASTER
!
Press the
"Master" key
for 2 seconds, then release it
IMPORTANT: the above procedure can be used to pair all channels not yet paired with a "Master", to a "Master"
chronothermostat that has itself not yet been paired with any receiver channel as primary device.
CANCELLING THE PAIRING OF CHANNELS WITH A "MASTER"
Select "Master Test" mode on the MASTER
ON THE RECEIVER
The channel LEDs flash if the channels are paired with the active "Master".
!
Press and hold the
button
be cancelled until you hear one beep, then release it. The LED for the channel
in question goes out and the channel pairing with the "Master" is cancelled.
!
Repeat the above operation for all the other channels whose pairings you
wish to cancel.
Exit "Master Test" mode on the MASTER
10
).The new transmitter is
CHRONO
THERMOSTATS
CHRONO
THERMOSTAT
"
"
disappears from the display.
in the
chrono
thermostat manual .
button until you hear one beep, then release it.
is now ready to be paired with the
).
CHRONO
THERMOSTAT.
.
CHRONO
THERMOSTAT.
for the channel whose pairing with the "Master" is to
CHRONO
THERMOSTAT.
1
2
"C"
RESET
(
if required
)
)
1
2
"Master"
1
2
8
1
2
2
s
Fig. 10
control or by a power
1
2
F
ig.1
1
1
2
F
ig.
12
Publicité
