Perry 1TXRX0801-P Mode D'emploi page 3

ENGLISH
TECHNICAL SPECIFICATIONS
Supply voltage:
Device Absorption:
Type of appliance:
Type of output:
Wire section at terminals:
Maximum length of bus connection
Reception frequency band :
Maximum signal capacity in free air:
Maximum signal capacity in the presence of walls:
Signal reception mode:
Type of insulation:
Protection degree:
Pollution:
Operating temperature limits:
Storage temperature limits:
PERFORMANCE DATA
!
system operation with master chronothermostats
Possibility of
Master).
!
Pump ( or boiler ) control
!
Delayed pump (or boiler) control (120 second delay).
!
Coupling transmitters in self-learning mode, facilitated by luminous and audio signals.
!
It is possible to erase a transmitter coupling to the zone even in the event of transmitter failure.
!
Manually forcing the state of the output to test the system (5 minutes, resettable).
!
"RESET" command to erase temporary data in memory and deactivate commands.
!
Permanent, modifiable memory, for coupling the transmitter and assigning the Master.
!
Luminous signals indicating malfunctions due to the absence of transmission or an almost dead battery.
!
Highly reliable communications thanks to the
!
Lighted and/or audio signal, on 3 levels, of the TEST signal to verify the presence and capacity of the signal
(VMETER).
SEE THE CONTROL B OX 'S OWN MANUAL FOR THE RELEVANT TECHNICAL SPECIFICATIONS AND PERFORMANCE DATA.
Dimensions
1
Fig. .i 1
18 V~50
1 VA max
Electronic
encrypted on two-wire RS485 bus
min.
: 100 m (
« 868
120 m
30 m according to the chap. 1.1 and to the chap. 1.4)
antenna internal to the receiver
Class II
IP 30 / wall-mounted
normal
-20 °C ÷ + 70 °C
-25 °C ÷ + 85 °C
simultaneous with the control of one of more solenoid valves.
double transmission of data
ON
2 3 4 5 6 7 8
RESET
133
Hz ( from control b ox)
.
2 2
0,5 mm ÷ max. ,5 mm 1
minimum wire section 0,5 mm )
-868.6 MHz »
(
(see chronothermostat instructions - model with
.
3
2
25