hestan KVC Serie Installation, Usage Et Maintenance page 11

CLEANING AND MAINTENANCE
CLEANING CLEANING
Clean the shield(s) and/or blower housing(s) in a sink of warm soapy water (liquid dish detergent)
and let soak for a few minutes. Wash with a sponge or dishcloth, rinse and let drain before
reinstalling. Alternatively, the blower housing(s) and blower shield(s) may be placed into a
dishwasher.
1
Item # Description
1
Motor housing
2 Wheel
3 Blower housing with damper(s)
4 Blower shield
Regular cleaning of the blower housing should prevent grease accumulation on the blower wheel.
If grease build-up should occur, the blower wheel may easily be cleaned in place using a soft bristle
toothbrush and a common degreaser such as Formula 409®.
Take care not to move or lose the metal balancing clips that may be affixed to
the wheel.
Item # Description
1 Balancing clip
2
Blower wheel
2
To reduce the risk of personal injury, be sure the power is turned off in
the hood before removing the shield(s) and blower housing(s).
1
(CONT.)
3
4
2
©2020 Hestan Commercial Corporation
EN
7