Double Switch Installation; Hotel Switch Installation - Smartwares SH8-90604 Guide De Démarrage Rapide

3 | Installation
Illustration 5: Mark position and re-
move cables
Illustration 6: Connect power to
connection terminal
Illustration 7: Connect switch con-
verter to the light switch
Illustration 8: Mark position and re-
move cables on switch 1
8

3.4 Double switch installation

Follow the procedure below to install the wall switch converter on a double button
light switch.
Before you start, make sure that you have:
ü Switched off the mains supply breaker.
ü Measured that there is no power present, using a voltage meter.
ü Installed the battery in the wall switch converters. (See section "Install the switch
converter battery".)
ü Paired the light bulb with the wall switch converters. (See section "Pair light bulb
to switch converter".)
a) On the light switch: Remove the switch face-plate. (See illustration 5)
b) Loosen and remove the screws holding the switch in place.
c) Mark the terminals where the cables are connected.
d) Remove the cables from the light switch.
e) Insert the cables into the connection terminals. (See illustration 6)
f) On the light switch: Connect the cables of the wall switch converter to the termin-
als that you marked on the light switch.
Important: Install as shown in illustration 7. Yellow cables on one side and white on
the other of the light switch. If white and yellow are mixed, damage to the unit may
occur.
g) Repeat step f) for the second wall switch converter.
h) Put the light switch in place and fasten the screws.
i) Put the face plate in place and press to fasten.
j) Switch on the mains supply breaker.
Caution: Do not let the wall switch converter come into contact with the mains power
cables. Make sure that all cables are disconnected from your regular light switch be-
fore installing the wall switch converter.

3.5 Hotel switch installation

Follow the procedure below to install the wall switch converter on a single button
hotel switch.
Before you start, make sure that you have:
ü Switched off the mains supply breaker.
ü Measured that there is no power present, using a voltage meter.
ü Installed the battery in the wall switch converter. (See section "Install the switch
converter battery".)
ü Paired the light bulb with the wall switch converter. (See section "Pair light bulb to
switch converter".)
a) On the light switch: Remove the switch face-plate. (See illustration 8)
b) Loosen and remove the screws holding the switch in place.
c) Mark the terminals where the cables are connected.
Smartwares
SH8-90604_IM