Installation; Insert The Switch Battery; Pairing The Wall Switch Convertor; Pairing Additional Lights - Smartwares SH8-90604 Guide De Démarrage Rapide

3 | Installation

Illustration 1: Switch battery lid
6
3 Installation

3.1 Insert the switch battery

As the wall switch converter will convert your standard light switch into a wireless
switch, a battery is required. Follow the procedure below to insert the battery (see il-
lustration 1):
a) Rotate the lid of the switch counter clockwise (see markings on the lid).
b) Remove the lid.
c) Insert the battery (text on battery facing up).
d) Place the lid and rotate clockwise to fasten.

3.2 Pairing the wall switch convertor

To make the wall switch converter function, it first must be paired. You can choose to
either pair it to the Link gateway, or to a compatible light bulb.
Please keep in mind that when the wall switch convertor is paired to a bulb, your tradi-
tional wall switch is not operable with the HomeWizard Link app.
Important: The wall switch converter does not need to be connected to a light switch
for the pairing to function. The pairing procedure is a preparation for the actual install-
ation. (See installation sections).
Pair convertor to Link gateway
You can now start to add the wall switch converter to the Link gateway.
a) In the HomeWizard Link app, go to settings, and tap "add device".
b) Select the Wall switch converter from the list, and follow the steps in the app to
successfully add the device.
ð You can now start with the installation of the Wall switch converter.
Pair converter to a light bulb
Follow the procedure below to complete the pairing process.
Before you start, make sure that you have:
ü Installed the light bulb in a compatible socket with the power turned off.
c) On the wall switch converter: Press and hold the button for 5 seconds or after the
LED flashed 8 times and starts flashing rapidly. (The LED will flash as soon as you
press the button but will increase in speed after 5 seconds)
d) Turn the light bulb on. (The light bulb will start to flash if successful.)
e) If you for any reason need to reset the wall switch converter, press and hold the
button for 10-15 seconds.
ð You can now start with the installation of the Wall switch converter.
Note: If you wish to connect additional lights, please refer to chapter 3.2.1.

3.2.1 Pairing additional lights

You can control multiple lights with one wall switch convertor. To add more lights to
the first paired light follow below procedure:
Smartwares
SH8-90604_IM