Single Switch Installation - Smartwares SH8-90604 Guide De Démarrage Rapide

Smartwares
Illustration 2: Mark position and re-
move cables
Illustration 3: Connect power to
connection terminal
Illustration 4: Connect switch con-
verter to the light switch
SH8-90604_IM
a) Make sure the light bulb you wish to pair is unscrewed.
b) Press and hold the button on the wall switch convertor for a short period (<1
second), the LED will start flashing.
c) Screw the light bulb in the socket.
d) The light will flash orange and blue to indicate that it is paired to the wall switch
convertor.

3.3 Single switch installation

Follow the procedure below to install the wall switch converter on a single button light
switch.
Before you start, make sure that you have:
ü Switched off the mains supply breaker.
ü Measured that there is no power present, using a voltage meter.
ü Installed the battery in the wall switch converter. (See section "Install the switch
converter battery".)
ü Paired the light bulb with the wall switch converter. (See section "Pair light bulb to
switch converter".)
a) On the light switch: Remove the switch face-plate. (See illustration 2)
b) Loosen and remove the screws holding the switch in place.
c) Mark the terminals where the cables are connected.
d) Remove the cables from the light switch.
e) Insert the cables into the connection terminal.
f) On the light switch: Connect the 2 cables of the wall switch converter to the ter-
minals that you marked on the light switch (any order, see illustration 3 and 4).
g) Put the light switch in place and fasten the screws.
h) Put the face plate in place and press to fasten.
i) Switch on the mains supply breaker.
Caution: Do not let the wall switch converter come into contact with the mains power
cables. Make sure that all cables are disconnected from your regular light switch be-
fore installing the wall switch converter.
Installation | 3
7