afriso MSW Notice Technique page 29

5.4 Replacing the product
HOT LIQUID
The liquid in systems is under high pressure and can have temperatures of up
to 95 °C.
• Verify that the liquid has cooled down before replacing the product.
• Verify that there is no pressure in the system before replacing the product.
Failure to follow these instructions can result in death, serious injury or
equipment damage.
 Verify that the nominal pressure of the product corresponds to the speci-
fication value of the system.
 Verify that liquid can escape via the discharge line during heating up.
When the system has cooled down and is unpressurised, you can replace the
product.
1. Mount the product as described in chapter "Mounting the product".
Mounting
WARNING
EN
12
MSW