Step 3 Hardwiring To Power - Wilson Electronics weboost Drive Reach Flex Fleet Guide D'installation

STEP 3 Hardwiring to Power

The Drive Reach Flex Fleet kit includes a CLA and Hardwire power option . The CLA
power can be connected to a vehicle cigarette lighter port . Hardwire instructions are
below . Use the steps below as a general template for wiring the power. There are
multiple options for wiring and steps will vary depending on the vehicle type.
■ Locate the vehicle fuse box . The fuse box location will vary by vehicle, refer to the
vehicle's owner's manual .
■ Route the power cable from the booster to the fuse box . If the fuse box is located
under hood of the vehicle the cable will need to be ran through the firewall . Most
vehicles will have a designated spot to run cable from the cabin to the engine bay .
■ Determine which fuse to hardwire the power to . Find an open fuse slot that is
ignition-switched, if there are no open fuse slots tied to the vehicle ignition power
can be attached to an existing fuse . Wiring to an ignition-switched fuse will ensure
the booster is not drawing power when the vehicle is off . Refer to the vehicle
owner's manual for information about the fuses .
Note: You can use a circuit tester to test if the fuse is constant or ignition-switched .
A constant fuse will stay on when the vehicle is off, and an ignition-switched fuse
will have power when the vehicle is on but no power when it is off .
6 ENGLISH