Wilson Electronics weboost Drive Reach Flex Fleet Guide D'installation page 9

(STEP 3 cont .)
■ Connecting the power supply . Once you have determined a fuse slot to use connect
the positive lead on the power cable to the included in-line fuse then attach to a
fuse tap and crimp into place (fuse tap is not included in the kit and will vary by
vehicle type) . Connect the fuse tap to the fuse slot you have chosen .
Note: You will need to determine which type of fuse tap is needed to complete the
power wiring . Variations include ATO, Mini, Low Profile and Micro2 . Consult the
vehicle owner's manual to determine which fuse is needed for your installation .
■ Grounding the power supply . Most vehicle will have a factory grounding point .
Slip the negative lead "black" on the power supply under the metal bolt on the
grounding point and tighten into place .
■ Testing the booster power . With the power supply hardwiring completed and inside
and outside antennas in place attach the power supply to the booster . Turn the
vehicle ignition on and make sure the booster power lights turn on . Then turn the
ignition off to make sure the booster powers off .
ENGLISH 7