Publicité
Les langues disponibles
Les langues disponibles
English
Switch (Fig. A)
On/Off Button
1. To turn the light on, press the on/off button
shown in Figure A.
2. To turn the light off, press the button again
Installing and Removing the Battery Pack
(Fig. B)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
2
button
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. B
2
1
Pivoting Head (Fig. C)
4
The pivoting head
rotates within the 100° pivot range.
Fig. C
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
6
3
1
into the tool handle, align the
4
Repairs
The charger and battery pack are not serviceable. There are
no servicable parts inside the charger or battery pack.
as
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a CRAFTSMAN
factory service center or a CRAFTSMAN authorized
service center. Always use identical replacement parts.
Accessories
WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Versatrack (Fig. D)
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect power source
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal
injury, do not use a damaged Versatrack hang
hook or Versatrack Trackwall. A damaged
Versatrack hang hook or Versatrack Trackwall will not
support the weight of the tool.
WARNING: To reduce the risk of serious personal
injury, ensure the screw holding the accessory is
securely tightened.
WARNING: To reduce the risk of serious personal
injury, DO NOT suspend tool overhead or
suspend objects from the hang hook. ONLY hang
tool's hang hook on the Versatrack Trackwall.
WARNING: Ensure that the tool weight does
not exceed the maximum rated weight for the
selected Versatrack hook.
WARNING: When hanging objects on the
Versatrack wall, adequately space the tools in
order to not exceed 75 lb per linear foot.
iMPORTAnT: When attaching the Versatrack hang hook,
use only the screw that is provided. Be sure to securely
tighten the screw.
Versatrack accessories mount securely to the track.
1. The Versatrack hang hook
using only the provided screw
hook is not desired at all, it can be removed from
the tool.
2. To remove the Versatrack hang hook, remove the screw
that holds the Versatrack hang hook.
Versatrack accessories mount compatible tools securely to
the Versatrack Trackwall.
7
can be attached to the tool
8
. If the Versatrack hang
Publicité
