Care And Maintenance - Avanti WD360 Manuel D'instructions

OPERATING YOUR WATER DISPENSER
Steps to replace water bottles
Use a clean cloth to wipe off neck of bottle.
Remove cap.
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
Wipe off any water which may have splashed on dispenser top.
Cold Water Control
To turn on the cooling operation, use the power switch at the back of the unit. The green (power)
indicator will be lit as the cooling process begins.
temperature the blue (cold) indicator will turn on and will remain lit until the unit starts the cooling
process again.
Cup Dispenser (Optional)
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located
near the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting
bracket and screws and may be ordered by completing the enclosed order form provided with your
instruction manual.
•
Wash the inside of the reservoir with a warm water and baking soda solution. The solution should
be about 2 tablespoons of baking soda to a quart of water.
•
The drip tray and water faucets should be cleaned with mild detergent and warm water.
•
At regular intervals or once a month inspect the coils located across the back of the dispenser.
Vacuum accumulation of dust or clean it with a hard brush.
•
If the water dispenser will not be used for a long period of time, unplug the power cord from the
wall outlet.
•
Drain the water through the faucets.
•
Drain the water from the tanks by removing the plug from the water drain on the back of the
dispenser.

Unit should not be transported on the sides. Place it upright if possible and cover it with a
blanket.

CARE AND MAINTENANCE

TAKING DISPENSER OUT OF SERVICE
Once the water reaches the appropriate
12