Dispensing Water; Care And Maintenance; Taking The Dispenser Out Of Service - Avanti WDBMC800Q3S Manuel D'instructions

DISPENSING WATER

To dispense hot water:
¨ Slide red safety button to the right and hold while pressing downward on hot water faucet to
dispense hot water.
¨ Safety button will return to its original position when faucet is released.
¨ Ensure all water has dispensed prior to removing glass from the dispensing area.
To dispense cold water:
¨ Press and hold downward on the cold water faucet to dispense cold water.
¨ When you have dispensed the desired amount of water, simply release the cold water faucet.
¨ Ensure all water has dispensed prior to removing glass from the dispensing area.
·
Wash the inside of the reservoir with a warm water and baking soda solution. The solution should
be about 2 tablespoons of baking soda to a quart of water.
·
The drip tray and water faucets should be cleaned with mild detergent and warm water.
·
At regular intervals or once a month inspect the coils located across the back of the dispenser.
Vacuum accumulation of dust or clean it with a soft bristled brush.
·
If the water dispenser will not be used for a long period of time, unplug the power cord from the
wall outlet.
·
Drain the water through the faucets.
·
Turn the switch market hot to the "OFF" position.
·
Drain the water from the tank by removing the plug from the back of the dispenser.
WARNING—THE WATER COMING OUT OF THE BACK SIDE MARKED "HOT" MAY BE SCOLDING.
l
Unit should not be transported on the sides. Place it upright if possible and cover it with a
blanket.

CARE AND MAINTENANCE

TAKING DISPENSER OUT OF SERVICE
12