Télécharger Imprimer la page

Sunex Tools 6603ASJPK Manuel Du Propriétaire page 2

Masquer les pouces Voir aussi pour 6603ASJPK:

Publicité

Les langues disponibles

Les langues disponibles

WARNINg INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THESE DEVICES, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these devices. It is also the responsibility
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are
lost or not legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be
read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that
the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and
operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper
use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack and jack stands before each use. Do not use jack or stands if damaged, altered, modified, in poor condition,
leaking hydraulic fluid, or unstable due to loose or missing components. Make corrections before using.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• Do not use jack or jack stands beyond their rated capacity. Do not shock Load.
• Apply the emergency brake, put the gear shift lever in park or in gear if a manual shift transmission, and chock the tires that will
not be lifted off the ground.
• Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering operations.
• Do not move or dolly the vehicle while on the jack.
• Do not use any materials that may serve as risers, spacers or extenders between the stock lifting saddle and the load.
• Do not use any adaptors that replace the stock lifting saddle unless approved or supplied by the jack manufacturer.
• This is a lifting device only. Immediately after lifting, support the vehicle with jack stands capable of sustaining
the load before working on the vehicle.
• Do not crawl under vehicle when placing/removing stands.
• Always lower the jack slowly and carefully.
• Maximum load capacity per matched pair of stands shall not exceed the rated capacity of the individual stand.
• Stands are to be used in matched pairs to support one end of a vehicle only. Do not simultaneously support both ends
or one side of a vehicle.
• Consult the vehicle manufacturer for the proper frame support locations.
• Check the stands for solid contact with the ground and vehicle.
• Make sure the stand's locking pins are fully engaging the stand on both sides and the support column saddle is making contact
with a vehicle support surface that can support the load.
• Ensure both stands are set at same height and locking pins are fully engaged
• Center load on saddle. Be sure setup is stable before working on vehicle.
• This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
6603ASJPK
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
07/08/15

Publicité

loading

Ce manuel est également adapté pour:

1003aj6603asj