Cleaning; Floor Nozzle; Dust Container With Filter Unit; Storage - Profi Care PC-BS 3036 A Mode D'emploi

3. Cleaning the Filters
3.1 Hold both filters over a garbage can and tap out the
dust. You may also brush out the HEPA filter. In case
of heavy staining, clean the filters under running
water.
3.2 Let the filters air-dry completely before refitting them!
3.3 Wipe the dust container with a damp cloth and then
wipe it dry.
4. Assembly of the Filter Unit
4.1 Place the coarse filter in the dust container. Please
note the recess on the edge of the dust container.
Now push the coarse filter down so that it is placed
in the centre of the dust container.
4.2 Place the HEPA filter back into the coarse filter.
4.3 Then reattach the dust container to the handset.
Attach the dust container to the handset with the
WARNING:
• Always disconnect the appliance from the power adapter before

cleaning!

• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The single components are not dishwasher-safe.
• Wipe the casing with a damp cloth.
• You can wipe the power adapter appliance with a dry
cloth.

Floor Nozzle

1. Disconnect the floor nozzle from the suction pipe.
2. Turn the floor nozzle around, so that you see the lower
side. Push the lock outwards as far as it will go.
3. Pull out the brush roller.
52
PC-BS3036A_IM_new (ab PO60756)
symbol positioned below the mark on the handset.
Then turn the dust container anti-clockwise as far as
it will go. The
be located below the marking on the handset.
Outlet Filter
The appliance is also equipped with an exhaust filter. It is
located at the top of the motor housing.
1. Press the PUSH button (17) to be able to remove the
cover.
2. Remove the ring-shaped foam filter and wash it out.
3. Allow the foam filter to air-dry completely before reinsert-
ing it into the appliance.
4. Put the cover back onto the motor housing. The latch
below the PUSH button must audibly engage.
Cleaning
4. Remove threads and hair wound to the brush. Use
scissors, if required.
5. Assembly:
5.1 Reinsert the brush roller, with its triangular recess
first, into the compartment.
5.2 Insert the other end of the brush roller with the
square bearing into the recess underneath the
closure.
6. Close the lock of the brush roller. Make sure the brush
roller is properly placed before using the floor nozzle
again.

Dust Container with Filter Unit

Please read the chapter "Maintenance" for cleaning of these
components.
• Clean the appliance as described and allow it to dry.
• You can use the previously installed wall holder for

storage.

symbol on the dust container must
Storage
07.05.21