oneConcept 10028322 Mode D'emploi page 13

Note: Never add hard chips to a fountain while the motor is running. only
add melted, smooth chocolate. Make sure no chunks of food are in the base
as it may clog the flow of chocolate. Remove with a slotted spoon.
CLEANING AND CARE
• Unplug the power plug before you clean the unit. And allow the unit to
cool down.
• Do not immerse the base unit (B) in liquids of any kind!
• Use only a moist cloth to clean base unit (B). Allow the unit to dry fully
before the next use.
• Immediately after use, clean the container (A), the cascade tower (F) and
the auger (G) with warm water, detergent and a cloth to prevent food
residue from sticking. And then use a dry cloth to dry them.
• The auger (G) and cascade tower (F) (after cooling) can be cleaned in
the dishwasher, before putting the items into the dishwasher, remove
excessive contaminations in the sink or with paper tower.
• Do not use metal or sharp items to clean the unit, because these may
damage the surfaces.
• Do not use aggressive chemicals or similar materials.
TROUBLESHOOTING
Problem
Chocolate is dripping,
not flowing.
Flow is intermittent,
interrupted,
flowing not properly.
Mögliche Ursache
Chocolate is too thick.
Unit is not LEVEL.
Check whether chunks
of food is in base which
may clog the chocolate
flow.
Lösung
Add some vegetable oil.
Level the unit.
Remove any chunks
with a slotted spoon.
EN
13