Tripp-Lite SmartPro Serie Manuel Du Propriétaire page 9

Basic Operation
continued
Other UPS Features (Rear Panel)
AC Receptacles: Your UPS features C13 outlets. These output
receptacles provide your connected equipment with AC line power during
normal operation and battery power during blackouts and brownouts. The UPS
protects equipment connected to these receptacles against damaging surges and
line noise. If you have a serial or USB connection to your UPS, you can
remotely reboot connected equipment by turning individually controllable
C13
receptacles OFF and ON using Tripp Lite's PowerAlert Software. Three
receptacles, labeled LOAD 1, LOAD 2 and LOAD 3, are individually
controllable and may be remotely switched OFF and ON using PowerAlert
Software without interrupting power to equipment connected to other outlets.
Outlets labeled UNSWITCHED may not be remotely turned off. Unswitched
outlets can only be turned off by turning off all output receptacles. See software
instructions for details.
Communications Ports (USB or RS-232): These ports connect your UPS to
any workstation or server. Use with Tripp Lite's PowerAlert Software and
included cables to enable your computer to automatically save open files and
shut down equipment during a blackout. Also use PowerAlert Software to
monitor a wide variety of AC line power and UPS operating conditions. Consult
your PowerAlert Software manual or contact Tripp Lite Customer Support for
more information. See "USB and RS-232 Serial Communications" in the
"Optional Installation" section for installation instructions.
EPO (Emergency Power Off) Port: Your UPS features a EPO port that may
be used to connect the UPS to a contact closure switch to enable emergency
inverter shutdown. See Optional Installation.
9