KOBE CH00 Série Manuel D'installation Et Mode D'emploi page 18

Duct Cover Installation
6. Use 6" round steel pipe for 30" and 36" models or 8"
round steel pipe for 42" and 48" models (follow
building codes in your area) to connect the exhaust
on the hood to the ductwork above. Use duct tape
to make all joints secure and air tight. Refer Figure
20.
7. Use four 4mm x 8mm screws (included) to attach duct
cover to hood. Refer to Figure 21.
Install Accessories
8. Attach oil tunnel. Refer to Figure 22.
9. Refer to Figure 23.
hood. Push the baffle filter upward.
forward. Pull downward.
10. Repeat until all baffle filters and spacers are resting
against oil tunnel. Refer to page 23.
Final Assembly
11. Turn power ON in control panel. Check all lights and
fan operation.
12. Make sure to leave this manual for the homeowner.
Slide the baffle filter into the
Fit into place.
Figure 22
Figure 23
Slide
16