Publicité
Les langues disponibles
Les langues disponibles
Many problems have a simple cause and a correspon-
dingly simple solution. The following section describes a
few difficulties you may encounter, and the measures you
need to take to cure them.
If you find it impossible to solve a problem with the help of
these notes please disconnect the unit from the mains
and ask your authorised specialist dealer for advice.
Problem:
Machine does not switch on (LED does
not light up).
Mains lead not plugged in correctly.
Cause 1:
Check connection, push connector in
Remedy:
firmly.
Mains fuse burned out.
Cause 2:
Have the mains fuse in the mains input
Remedy:
socket replaced by an authorised specia-
list workshop. The rating of the replace-
ment fuse must agree with the specifica-
tion printed on the unit.
Problem:
The unit does not respond to com-
mands.
Static discharge or powerful interference
Cause:
(e. g. lightning) have corrupted the pro-
cessor memory.
Disconnect
Remedy:
1 minute and re-connect. Switch unit on
again.
Problem:
Machine responds correctly to manual
operation of the buttons, but does not
respond to remote control commands.
Incorrectly inserted batteries or flat batte-
Cause 1:
ries in the remote control handset.
Re-install batteries correctly or fit new
Remedy:
ones.
Receiver incorrectly connected, or con-
Cause 2:
nector not plugged correctly into RC
socket on unit.
Complete the connections as shown in the
Remedy:
wiring diagram. Push in connectors firmly.
Inefficient receiver position
Cause 3:
Ensure direct line-of-sight contact between
Remedy:
remote control transmitter and receiver.
Note that glass doors may prevent the
system working properly. Maximum range
between transmitter and receiver approx.
8 metres.
Position the receiver in such a way that it
is not subjected to direct sunlight or strong
artificial lighting. Fluorescent and energy-
saving lamps are powerful sources of
interference.
Trouble shooting
mains
plug,
wait
about
Remote control address of amplifier and
Cause 4:
remote control transmitter do not agree.
Set remote control to Address 1 (see
Remedy:
remote control operating instructions).
If code converter is present:
Set remote control to address of con-
verter.
Problem:
The machine does not respond to re-
mote control commands after you fit
new batteries in the remote control
handset.
(only if code converter is present)
The remote control was set to remote
Cause:
control address 2 before you changed
batteries. This setting is lost when you
change batteries.
Switch to remote control address 2 (see
Remedy:
remote control operating instructions).
Problem:
The source devices connected to the
system does not respond to remote
control commands.
The unit you are trying to control is not
Cause 1:
selected as source device, i. e. the com-
mands from the remote control handset
are being passed to a different source
device.
Press the corresponding source button on
Remedy:
the remote control handset and try again.
The source device is not connected via an
Cause 2:
cable.
R
LINK
Complete the connection as shown in the
Remedy:
wiring diagram.
Problem:
Loud
loudspeakers.
Poor contact between the Cinch plugs and
Cause:
sockets, or a faulty Cinch cable.
Please check all connections and cables
Remedy:
thoroughly.
40
humming
noise
from
the
Publicité
Chapitres
