Fcc Information To The User - T+A P 1260 R Mode D'emploi

Approved usage
This device is designed exclusively for reproducing
sound and/or pictures in the domestic environment. It is
to be used in a dry indoor room which meets all the
recommendations stated in these instructions.
Where the equipment is to be used for other purposes,
especially in the medical field or any field in which safety
is an issue, it is essential to establish the unit's suitability
for this purpose with the manufacturer, and to obtain
prior written approval for this usage.
 equipment which includes a radio or television
receiving section must be operated within the stipula-
tions laid down by the Post Office and the Telecommuni-
cations authorities in the country in which it is used.
This unit may only be used to receive or reproduce those
transmissions which are intended for public reception. The
reception or reproduction of other transmissions (e. g.
police radio or mobile radio broadcasts) is prohibited.

The only permissible method of disposing of
this product is to take it to your local collection
centre for electrical waste.
Care of the unit.
Disconnect the mains plug at the wall socket before clea-
ning the case.
The surfaces of the case should be wiped clean with a
soft, dry cloth only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that there are no
short-circuits at the connections, and that all cables are
plugged in correctly.
Approval and
directives
In its original condition the unit meets all currently valid
European regulations. It is approved for use as stipula-
ted within the EC.
By attaching the CE symbol to the unit  declares its
conformity with the EC directives 89/336/EEC, amended
by 91/263/EEC, amended by 93/68/EEC, and also
73/23/EEC, amended by 93/68/EEC and the national
laws based on those directives.
The original, unaltered factory serial number must be
present on the outside of the unit and must be clearly
legible! The serial number is a constituent part of our
conformity declaration and therefore of the approval for
operation of the device.
The serial numbers on the unit and in the original 
documentation supplied with it (in particular the inspec-
tion and guarantee certificates), must not be removed or
modified, and must correspond.
Infringing any of these conditions invalidates  con-
formity and approval, and the unit may not be operated
within the EC. Improper use of the equipment makes the
user liable to penalty under current EC and national
laws.
Any modifications or repairs to the unit, or any other
intervention by a workshop or other third party not autho-
rised by , invalidates the approval and operational
permit for the equipment.
Only genuine  accessories may be connected to the
unit, or such auxiliary devices which are themselves
approved and fulfil all currently valid legal requirements.
When used in conjunction with auxiliary devices or as
part of a system this unit may only be used for the pur-
poses stated in the section 'Approved usage'.

FCC Information to the user

(for use in the United States of America only)
Class B digital device – instructions:
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and
-
receiver.
Connect the equipment into an outlet on a circuit dif-
-
ferent form that to which the receiver is connected.
Consult the dealer or an experienced radio/TV techni-
-
cian for help.
33
conformity with EC