oneConcept 10027962 Mode D'emploi page 15

CD programming
Up to 20 tacks can be programmed for disc play in any order. Before use, be sure to press
the " stop " button (2).
1. Set in CD mode & stop the CD playback.
2. Press the "Program" button (9), " PROG " will appear & fl ashing on LCD display (1).
3. Select a desired track by pressing skip up
4. Press the "Program" button (10) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press " play/pause
(7) to play the song in assigned order.
7. Press the "stop
• After program complete, press "Program" button (9) to review the tracks being
programmed.
• Press "stop " button (2) at CD stop mode to cancel all programmed memory until the
"PROG" indicator disappear on LCD display (1).
Remark:
Due to Aux and CD being designed at the same position of this system.
When Aux-in jack (14) plugged by 3.5 mm stereo plug. The channel will
change to Aux automatically and CD will stop to play. Please ensure the
Aux-in jack (14) without plugged by anything before playing CD.
Playback of MP3 song via USB storage media
Connecting
• The system is able to decode and playback all MP3 fi le which stored in the memory
media via USB host.
NOTE : LCD does not display anything during USB playback due to products design.
1. Set the system at standby mode fi rst or other function except USB mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into completely.Con-
necting the USB upside down or backwards could damage the audio system or the
storage media (USB thumb driver). Check to be sure the direction is correct before
connection.
3. Slide the functions selector (18) to USB mode. The USB/BT indicator (10) will light up
4. The system will start reading and playback the storage media automatically after con-
necting, the USB/BT indicator will change to fl ash mode during playback.
5. Press "skip up " button (8) or
(7) to change to stop mode.
" button (2) to terminate program play.
button (3) to skip the track. Press play/pause button
or down buttons (8/3) .
" button
15