Klarstein INNOCHEF Mode D'emploi page 36

EN
36
Problem Possible causes
Fan noise com- A cooling fan built into your
ing from induction hob has come on to
the induction prevent the electronics from
hob. overheating. It may continue to
run even after you ve turned the
induction hob off.
Pans do not 1. The induction hob cannot
become hot. detect the pan because it
is not suitable for induction
cooking.
2. The induction hob cannot de-
tect the pan because it is too
small for the cooking zone or
not properly centred on it.
The induction Technical fault.
hob or a
cooking zone
has turned
itself off
unexpectedly,
a tone
sounds and an
error
code is dis-
played.
Error Codes
E0 Without cookware or Incompatible
cookware used
E1 IGBT sensor open circuit/short circuit
E2 Internal overheat
E3 Over-voltage
E4 Under-Voltage
E5 Top plate sensor open/short circuit
E6 Top plate overheat
What to do
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Use cookware suitable for
induction cooking. Centre the
pan and make sure that its base
matches the size of the cooking
zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
When displaying faults E0, E2
and E6, please check whether
the cookware is not suitable
or switch the appliance on
again after it has cooled
down naturally. If the display
shows E1 or E3-E5, contact
a specialist company for
inspection and repair.