Publicité
Installation Data
D9 female pin assignment:
Connector RJ45:
PIN
1
2
3
6
Initial factory setting:
•
Button reset 5sec. up recovery initial factory
•
Password: no
•
IP address: 192.168.1.1
Dimension of the housing:
English
NO D9 Male
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9
TX+
TX-
RX+
RX-
•
Gateway address: 192.168.1.254
•
Subnet mask: 255.255.255.0
Set up steps – Software:
1.
On the driver CD go to the directory 'RS232 Device Server'.
2.
According to your Windows version (32 or 64 Bit), open up
the respective subdirectory ('Serial Device Server -<OS
suffix>', where 'OS suffix' means 'x86' for a 32Bit Windows
and 'amd64' for a 64Bit Windows).
3.
From this directory run the file 'ATILDST<serial no.><OS
suffix>.exe. The term 'serial no.' may vary depending on the
driver version.
4.
The following Windows will open subsequently and require
your action before the installation can be started:
•
"Licence Agreement" ->
•
"Choose Components", we recommend to choose "full" -
>
•
"Choose Install Location", we recommend to leave this as
suggested ->
•
"Completing the Atil Device Server Toolkit Setup Wizard"
->
5.
After completing the installation process, from the start or
metro menu, the software "Atil VSP Manager" may be started.
Configuration via network
•
Open your browser and navigate to
•
In the original factory settings, no password is required -
just click 'Login'.
•
Adjust your settings to your needs as described in the file
"RS232 Device Manager - manual.doc" on the CD.
Application
Virtual Serial Port Driver installation guide for Windows
XP/7/8.x 32bit - 64bit
ATILDST-5-09-02-amd64 for 64bit windows operation system
ATILDST-5-09-02-x86 for 32bit windows operation system
RUN ATILDST-5-09-02-x86
http://192.168.1.1
English
Publicité
