Clevo W650SR Guide Utilisateur Concis page 12

• For Windows 8 32bit = D:\Options\RAID\f6flpy-x86
• For Windows 8 64bit = D:\Options\RAID\f6flpy-x64
4. Start-up your notebook computer and press <F2> to enter the
BIOS.
5. Go to the Boot menu, select OS Select and press <Enter>.
6. Set OS Select to "Windows 8" and set UEFI Boot to
"Enabled".
7. Press <Esc> to exit the menu and go to the Advanced menu.
8. Select SATA Mode, press <Enter> and select "RAID Mode".
9. Press <F4> and <Yes> to "Save Changes and Reset".
10. After the computer restarts press <F2> to enter the BIOS again.
11. Go to Intel(R) Rapid Storage Technology (in the Advanced
menu) and press <Enter>.
12. Select Create RAID Volume and press <Enter>.
13. You can now setup your RAID volume using any two installed
disks.
14. Go to Name: and press <Enter>.
15. Type a name of your choice for your RAID volume and press
<Enter>.
6
16. Go to RAID Level: and press <Enter>.
17. Choose the RAID Level required (see
18. Go to any of the disks listed under Select Disks: and select a
19. Move the cursor down (use the arrow keys) onto X (o select the
If you have selected a Recovery level RAID then you
need to select one disk to be Master disk (M) and one
disk to be the Recovery disk (R).
20. You should select two identical disks to form your RAID volume.
Figure 2
Name the RAID 21. If you have selected RAID0 (Stripe) then you can adjust the
Volume (Ad-
vanced > Intel(R) 22. If you have selected Recovery then you can adjust the
Rapid Storage
Technology) 23. Go to Create Volume and press <Enter>.
press <Enter>.
• RAID0 (Stripe)/RAID1 (Mirror)/Recovery
disk name and press <Enter>.
disk required) and press <Enter>.
"Strip Size" to your requirements.
Synchronization to "On Request" or "Continuous".
Table 2 on page 5) and
Figure 3
Select
Disks