Basic Osd Setup (Osd); Selecting Screen Language; No Sync - gigamedia GGM CCMLCD17PP Manuel D'utilisation

2. Basic OSD setup
EN
2.1. Tu rning on and off the CCTV monitor
2.1.1. Turn on monitor
- Connect the AC input cable to monitor, then press the main power switch on monitor. At this time the monitor will
enter into stand by mode and the indicator light turn red.
- Using buttons can turn on monitor from stand by mode as follows: Press POWER key on front panel or on the remote
control.
2.1.2. Tu rn off monitor
- Press POWER button on front panel or on the remote control to enter standby mode. The indicator light is red.
- Using main power switch turns off monitor completely.

2.2. Selecting screen language

Note :
If you use your monitor for the first time, you should select the language which will be used for displaying menus and
indications.

2.3. No sync

10
- Press the "MENU" button into main menu.
34
- Press the " " button to select OSD menu.
56
- Press the " " button to select OSD LANGUAGE.
34
- Press the" " button to select your language.
- When you are satisfied with your choice, press MENU to exit.
There is NO SYNC menu on screen when there is no input signal.
www.gigamedia.net