Publicité
Les langues disponibles
Les langues disponibles
FI/RCD trip test,
PE (protective earth test)
The Multi-Tester Pro LED has a load which allows an
FI/RCD circuit breaker to be tripped by means of
two buttons (FI\RCD). The FI/RCD (max. 30 mA) is
tested between phase and PE conductor. Tripping is
indicated by two LEDs.
Battery changing
If the batteries have become discharged, a warning
signal sounds and the device switches off. Replace
the batteries immediately in order to ensure the
accuracy of the measured values.
To change the batteries, open the battery compart-
ment on the main housing.
Loosen the screws using a suitable screwdriver. Pay
attention that the new batteries are inserted with the
correct polarity!
Close the battery compartment again and tighten
the screws.
Maintenance / care
Keep the device always dry and clean. The
■
device may be cleaned using a damp cloth.
Environmental instructions
Do not thrown the device away with
normal household waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally sound manner.
Batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy-
cle batteries or dispose of with due care for the
environment.
12
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note).
Any damage arising is remedied by the supply
of spare parts or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop.
We reserve the right to make technical changes.
We accept no liability for printing errors.
Spare parts
If, despite careful manufacturing and testing pro-
cesses, the device should become faulty, have the
repair carried out by a Würth masterService®
station.
Always quote the article number shown on the name
plate in all enquiries or spare parts orders.
The current spare parts list of the device can be
viewed online at http://www.wuerth.com/partsman-
ager. Alternatively, contact your local Würth agency
for a hardcopy.
Publicité
